Page 1 of 1
Radiator Vents S2 Exige
Posted: Wed Apr 13, 2011 8:03 am
by davec03
My radiator vents on my S2 Exige has some rust on them. It looks to me like they have a plastic coating rather than being painted. Can anyone enlighten me a little. Something that needs a bit of attention in the future.
Re: Radiator Vents S2 Exige
Posted: Wed Apr 13, 2011 9:31 am
by philthy
The are powder coated, painting them with hammerite will be your best bet, they are bonded on at the back IIRC so wont come off.
Re: Radiator Vents S2 Exige
Posted: Sat Apr 16, 2011 12:29 pm
by chris_c201
Is this the same for the side intake grills and engine cover? Few bits on mine coudl do with being touched up but not quite sure where to start....
Hammerite and an artists brush while they are on feasible?
Cheers,
Chris
Re: Radiator Vents S2 Exige
Posted: Sat Apr 16, 2011 9:22 pm
by Stewart
When I had my exige I took of the side vents masked them up and gave them 2 or 3 coats of spray hammertite. I also did the front grill. Lots of masking required but is was so worth it it. It really enhance the car. The paint stood up well too although the car never really got to see any salty roads after that.
Re: Radiator Vents S2 Exige
Posted: Wed Apr 20, 2011 11:01 pm
by davec03
Removed the side scoops tonight and after a quick rub with a wire brush and a bit off masking and 3 coats of Hammerite....Job done, look brand new! They radiator vents pose a bigger challange though!!