Dundee garages? Quick wheel bearing fitment

Scottd · Post by **Scottd** » Mon Jan 21, 2008 2:59 pm

Anyone found any Elise friendly garages in Dundee recently? I've got the part I just need the wheel bearing fitted by Thursday.

There's a garage near me I was thinkin of trying but they look like dodgy barsteward

a place where they at least knew how to jack up the car would be fine.

Rich H · Post by **Rich H** » Mon Jan 21, 2008 3:07 pm

Falkland Performance did mine. Not too far out.

Scottd · Post by **Scottd** » Mon Jan 21, 2008 4:16 pm

Too far for my lazy ass

Dominic · Post by **Dominic** » Mon Jan 21, 2008 4:18 pm

Was Ali SLS not going up to aberdeen at some point?... poss swing by to you en-route?....

Scottd · Post by **Scottd** » Mon Jan 21, 2008 4:24 pm

Dominic wrote:Was Ali SLS not going up to aberdeen at some point?... poss swing by to you en-route?....

He's over qualified for just a wheel bearing

and I don't think he'll have a hydrolic press with him.

Rich H · Post by **Rich H** » Mon Jan 21, 2008 4:36 pm

He will have a hammer...

mckeann · Post by **mckeann** » Mon Jan 21, 2008 4:37 pm

RICHARDHUMBLE wrote:Falkland Performance did mine. Not too far out.

I got royally ripped off by Falkland when i needed wheel bearings done, so i would definaetly get Ali to do it. Much better service too.

Rag_It · Post by **Rag_It** » Mon Jan 21, 2008 4:41 pm

Archie's Tyre and Autocentre, they will do it for you, or Alistair Leith Motors, tell them Disco Dave sent you!!!

rossybee · Post by **rossybee** » Mon Jan 21, 2008 10:42 pm

...or CP Garage in Douglas - ask for Euan & tell him Ross sent you

Rag_It · Post by **Rag_It** » Tue Jan 22, 2008 10:27 am

Aye Ross, also told him about Euan who sorted out my MOT, albeit needed a retest! Nice chap though, although very busy!

rossybee · Post by **rossybee** » Tue Jan 22, 2008 11:00 am

Busy for a reason mate

Scottd · Post by **Scottd** » Tue Jan 22, 2008 12:18 pm

After all that.... I got up early this morning and took the hub off myself and got my dad to drop it off at nearest garage. I'm guessing nothing can go wrong just handing them hub + new bearing. Should save me a tenner too, fantastic!