Plumbing question.

Sanjøy · Post by **Sanjøy** » Thu Jun 25, 2015 11:05 pm

neil wrote:Can you get a pic of the pump? It should be possible to identify it from that

Send me a pic and I will fire it over to a boiler installer mate to guesstimate.

S

Stephen · Post by **Stephen** » Sat Jul 04, 2015 7:54 am

Tut
Is there a temp probe on the thermal store that controls the supply to the pump. If the pump runs on the bench it may be worth checking.

Sent from my Nexus 5 using Tapatalk

tut · Post by **tut** » Sat Jul 04, 2015 9:19 am

Cheers Sanj. Not sure Stephen but will try and find out.

Have a pic and it shows the model number on it, StarRS 25/6. However this lists at 1.5" not 2" but I measured across the outside of the threads whereas I think that it should be the inside diameter. I only unscrewed at one end to measure then connected again, so will take it off today and check if it is U/S.

This is the one that should be suitable as a replacement, photo is the bottom left.

http://www.ebay.co.uk/itm/151350599806? ... EBIDX%3AIT

tut

Stephen · Post by **Stephen** » Sat Jul 04, 2015 9:59 am

You could disconnect the electrics and just run a cable straight from a plug to test it.

Sent from my Nexus 5 using Tapatalk

tut · Post by **tut** » Sat Jul 04, 2015 11:35 am

Now why did I not think of that, I normally look for the easiest option.

tut

Stephen · Post by **Stephen** » Tue Jul 14, 2015 11:07 am

Did you get it fixed?

Sent from my Nexus 5 using Tapatalk

Scottish Elises

Plumbing question.

Re: Plumbing question.

Re: Plumbing question.

Re: Plumbing question.

Re: Plumbing question.

Re: Plumbing question.

Re: Plumbing question.