post cat lambda sensor stuck

steve_weegie · Post by **steve_weegie** » Sat Jun 23, 2007 6:31 pm

Hello everyone, n00b mechanic here again....

I'm in a bit of a pickle.... While trying to get the exhaust off, the post cat lambda sensor is determined not to unscrew. If i could get the exhaust out from under the car, i'd be happy tackling it with some unholy tools but i cant seem to find where the darn electrical connector is!

Anybody got any ideas?

Thanks,

Steve

steve_weegie · Post by **steve_weegie** » Sat Jun 23, 2007 7:49 pm

<snipped>

The connector had wedged its self between the engine compartment and the outside world. Got it out through the engine bay after cutting the cables

Now all i need is for the rain to stop

Steve

robin · Post by **robin** » Sat Jun 23, 2007 8:20 pm

You needed to remove the wheel arch liner, then the cable would have come through easily enough ...

Cheers,
Robin

Rich H · Post by **Rich H** » Sun Jun 24, 2007 9:21 am

When I tried to shift my old one it came undoen leaving the sender part in the exhaust....