1, Press, simultaneously, both buttons on a transmitter key until the key tale tell stops flashing (approx 10 secs). On release of the buttons, the key tell tale will light.
2, Repeat operation (1) for ALL the transmitter keys required to operate the system.
3, Enter the PIN: Turn the ignition on and off 3 times within 7 seconds; the security tell tale will light for 3 seconds.
4, Immediately the tell tale light goes out, switch ON the ignition.
5, Count the number of security tell tale flashes until equal to the first number of your PIN, then turn the ignition OFF then back ON again.
6, Repeat operation (5) for the remaining 3 digits of the PIN, remembering to turn the ignition OFF and back ON again after each code number. Note: If at any time a mistake is made when entering the PIN, turn the ignition OFF for 10 seconds and re-commence entering the PIN.
7, If the PIN is correct the tell tale light will be lit. Test operation of each transmitter key.
I get to entering the 2nd digit and when I turn the ignition OFF and then back ON again nothing happens. I should be getting the security tell tale flashing for the 3rd digit, but nothing happens. I’ve tried and tried, but always get stuck in the same place.
Anybody got any ideas?
