Yoko Advans - Standard Vs LTS - Badge engineering???

The place to "speak geek"
alcabs
Posts: 24
Joined: Fri Nov 03, 2006 12:07 pm
Location: Aberdeenshire

Post by alcabs » Mon Nov 06, 2006 11:31 pm

Dont worry about that, I made sure he ordered the right type of BFG's. (He will make more money on them as well, he's not that daft, more expensive tyre).
Car's in to get them fitted tomorrow (Tuesday).

I will see how she feels to drive and then might pay Mark up at Banchory a visit so he can give the car the once-over.

User avatar
campbell
Posts: 17378
Joined: Sat Mar 25, 2006 12:42 pm
Location: West Lothian
Contact:

Post by campbell » Mon Nov 06, 2006 11:37 pm

S1s wear the inside edge of fronts as standard. Either swap the wheels/tyres to the opposite side after a few K miles (careful if directional treads!), or accept the early binning.

I have some Geo Settings courtesy of Robin, they are lurking earlier in this sub-forum if you search on geometry etc.

Campbell

Post Reply