Wanted, temp sender socket

Rich H · Post by **Rich H** » Wed Jan 24, 2007 3:07 pm

Hi all,
I'm (probably You know me!) going to fit the oil/water temp sender gubbins I posted about earlier. Does anyone know where I can get another temp sender socket? Are they standard or are there any unused ones on the loom?

Ta
Rich

Post by **Shug** » Wed Jan 24, 2007 3:50 pm

Daresay I can hack one off one of my many looms, should you be stuck. Assume it's a standard fitment, I've seen it about in a few things.

Rich H · Post by **Rich H** » Wed Jan 24, 2007 4:19 pm

I'll go scrap yard diving then. Or I might just bodge it and use a spade connector squashed in pliers....

Post by **Shug** » Wed Jan 24, 2007 4:27 pm

RICHARDHUMBLE wrote:I'll go scrap yard diving then. Or I might just bodge it and use a spade connector squashed in pliers....

Bubba Gump engineering strikes again

Rich H · Post by **Rich H** » Wed Jan 24, 2007 4:38 pm

hiscot · Post by **hiscot** » Wed Jan 24, 2007 5:47 pm

if you mean the electral plug that fits onto the sender try a local motor factors
my mgzt required a fog lamp harness making up and it uses the same type off plug, i got two from brother who has a m/factors

Rich H · Post by **Rich H** » Wed Jan 24, 2007 5:55 pm

Cool, TVM the scrappies round here are useless.

robin · Post by **robin** » Wed Jan 24, 2007 8:40 pm

There should be a spare one on the loom tie wrapped up somewhere in the vicinity of the crank shaft pulley ... i.e. ready to fit to an oil temp sender, that being what it's there for

Robin