Locks

delands · Post by **delands** » Thu Mar 08, 2007 4:44 pm

I know its been discussed, but what was the fix to prevent the barrel going into door and sticking?

mrbennybennett · Post by **mrbennybennett** » Thu Mar 08, 2007 4:55 pm

Unscrew the round reflector on the inside of the door and a good spray, inside of the door at the back of the lock, of WD 40 or similar - then give it a few pushes in and out and that should do the trick

Well it has done on mine anyway

Anthony

The_Rossatron · Post by **The_Rossatron** » Thu Mar 08, 2007 5:55 pm

The WD 40 guys do some sort of silicon spray which works wonders.

Rich H · Post by **Rich H** » Thu Mar 08, 2007 6:33 pm

Lithium grease, aka white grease, waterproof, sticky and lasts ages. WD40 runs out or evaporates too quickly

delands · Post by **delands** » Fri Mar 09, 2007 12:18 am

Noted... For a temp fix I have sprayed grease directly round the edge which has helped a bit. Wife is using car tomorrow and I dont want her complaining that it is a cr@p car coz cant open/ close door.