The place to "speak geek"
-
les
- Posts: 293
- Joined: Wed Jan 31, 2007 10:41 pm
-
Contact:
Post
by les » Fri Jun 08, 2007 9:45 pm
Evening,
Well I've only owned the s1 elise for 4 months and this is the first opertunity I've had to clean out the interior!! On my voyage of discovery I found that the Seatbelt indicator was disconnected (someone already hacked it to pieces) and never fitted the connector block under the dirvers seat. Perhaps more worrying is that the run of wires including the speaker wiring along the rear parcel shelf (behind the cargo net)has a connector going no where. Is it meant to plug into something? I'll upload an image, when I find how to attach files to this forum

)
Cheers
Les
-
BiggestNizzy
- Posts: 8932
- Joined: Sun May 27, 2007 6:47 pm
- Location: Kilmarnock
-
Contact:
Post
by BiggestNizzy » Fri Jun 08, 2007 10:40 pm
I to have a chopped wire for the seatbelt inidcator I couldn't find the other end to reconnect it. although I did find a black with white stripe (if my memory is correct) as well any ideas ?
Sent from my ZX SPECTRUM +2A
-
s333fee
- Posts: 313
- Joined: Sun Feb 05, 2006 10:16 pm
- Location: broadband now working !!!!!!!
-
Contact:
Post
by s333fee » Fri Jun 08, 2007 11:17 pm
there should be two wires coming from the seat belt clip end and two wires that disappear into the centre console. You might need to fish about abit to find them as they can get stuck in the seat runners or under the seat. Might have to remove the seat and or the centre console as a final attempt. They are very small cables and only break again. Also they onlymake the light for the seat belt light up on the dash, no buzzer etc, so might only show up is floor pan is wet.
-
les
- Posts: 293
- Joined: Wed Jan 31, 2007 10:41 pm
-
Contact:
Post
by les » Fri Jun 08, 2007 11:33 pm
Cheers guys, I've had a quick look though the circuit diagrams on the S1 and can't find any other connector the the middle of the parcel shelf other than the alarm, I was wondering if it was the old wiring from the original "rover" alarms microwave unit
Les
-
BiggestNizzy
- Posts: 8932
- Joined: Sun May 27, 2007 6:47 pm
- Location: Kilmarnock
-
Contact:
Post
by BiggestNizzy » Sat Jun 09, 2007 8:02 am
I will have a fish about later on when i'm re fitting MKII of my electric boot opener.
P.S. anyone know anything about electric gates ?
Sent from my ZX SPECTRUM +2A