Page 1 of 1
S2 Bits
Posted: Thu Jan 26, 2006 12:06 pm
by mac
Help!
I've lost most, if not all of my undertray washers. Anybody know the spec of them inner and outer diameters?
Cheers
Mac
Posted: Thu Jan 26, 2006 12:08 pm
by gordon
Jeess. some folk will do anything to save some weight
Posted: Thu Jan 26, 2006 12:14 pm
by Shug
Lemme guess, you dropped them in the "Pit of Doom"...
If nobody's posted by tonight, I'll get a ruler out when I get in.
Posted: Thu Jan 26, 2006 12:25 pm
by mac
I think the car might have ate them - don't recall dropping them.
And it's now know as the "watery pit of doom" - think some tanking is required
Mac
Edited: For Shug's sake
Posted: Thu Jan 26, 2006 12:28 pm
by Shug
tank tape?
fish tank?
sherman tank?
(picky mood today faction)
Posted: Thu Jan 26, 2006 2:02 pm
by alicrozier
Could try these...
http://www.nord-lock.com
They work and I've got Jim using them on his exhausts.
Posted: Thu Jan 26, 2006 2:12 pm
by mac
In all honesty I've just lost them as time goes by and have picked up whatever has been lying around, probably getting smaller and smaller in size until now when it rattles as though it's not been done up properly. I've got a place where I can buy them from, so that's not a problem and I know the bolt size is 8mm - it's just the washer size I'm struggling for.
Cheers
Mac
Posted: Mon Jan 30, 2006 12:27 am
by Rich H
I just went into my friendly B&Q and got 8mm repair washers.
They are big penny washers, mild steel & galvanised. Just keep an eye on 'em. I picked up a rattle after the borders run and found 3 had worked loose.
HTH
Rich