Page 1 of 1

s1 alarm

Posted: Sat Apr 19, 2008 4:42 pm
by mainsy
is it possible to make the alarm more sensitive when someone leans in the car? i had my alarm turned on and leaned in to grab my ipod and it didn't go off :|

Re: s1 alarm

Posted: Sat Apr 19, 2008 5:00 pm
by MacK
I think you can turn it off, but not sure if you can turn it down.

It might also wait 30 secs (or similar) after arming the alarm till it sets the sensor.

Not sure though :roll:

Re: s1 alarm

Posted: Sat Apr 19, 2008 5:04 pm
by BiggestNizzy
isn't there a screw on the side of the sensor for adjusting the sensitivity, also I think it takes a few seconds for that to arm.

the position of the sensor doesn't help unless someones trying to knick your stereo

Re: s1 alarm

Posted: Sat Apr 19, 2008 9:56 pm
by Matelotman
My alarm gives a warning tone as soon as you reach in then goes off a second or so later

Re: s1 alarm

Posted: Sun Apr 20, 2008 12:17 am
by robin
Check that the sensor that lives at kidney height between the seats is actually still velcro'd to the metal panel rather than pointing straight down like it normally does ;-)

Cheers,
Robin