VHPD

[craigs135s]

Guys the car won't rev past 5.5 RPM...Every time it hits 5.5k it bounces back. Am sure this is safe mode but i could be wrong So has anyone got any ideas why this would happem?

I have been told one thing that it could be just want to see if anyone else comes up with anything.

Cheers
C

[jj]

Lots of posts on this on exiges.com, all point to the wheel speed sensor, see here for an example

http://www.exiges.com/ubbthreads/showfl ... #Post95927

[craigs135s]

Cheers JJ

Front clam was off last week so maybe it has came loose when it was taken off..

Cheers
C

[craigs135s]

JJ have a look on the eliseparts web site for a picture of the extended roof for the exige am sure theres one there.

Cheers
C

[robin]

If you don't tell us what car we cannot help ...

Cheers,
Robin

[craigs135s]

S1 Exige............

[BiggestNizzy]

Cheers JJ

Front clam was off last week so maybe it has came loose when it was taken off..

Cheers
C

The wheel speed sensor is on the rear passenger side hub

[craigs135s]

Your right Nizzy would help if i read the whole post on Exiges

Cheers
C

[philthy]

Same thing happened to mine about a year ago, happens to them all

[craigs135s]

Was it the sensor Phil

Cheers
C

[Dave]

happens to them all

Only if it's had the recall done for the miss fire detection, I've never had mine done because it seems to cause even more problems, plus I like to run with the wheel speed sensor disconnected, gives lots of pops and bangs on the overrun.

[renmure]

happens to them all

Only if it's had the recall done for the miss fire detection, I've never had mine done because it seems to cause even more problems, plus I like to run with the wheel speed sensor disconnected, gives lots of pops and bangs on the overrun.

I deliberately didn't have the miss fire detection recall and disconnected mine to get all the pops and bangs also.
( ok.. I just did what you told me to and it worked )

[craigs135s]

happens to them all

Only if it's had the recall done for the miss fire detection, I've never had mine done because it seems to cause even more problems, plus I like to run with the wheel speed sensor disconnected, gives lots of pops and bangs on the overrun.

I would say that confirms it then mate.. Since i got it bak a couple of days ago i noticed its poped and banged way more than it did before it went away. So i take it just clips back together?

Cheers
C

[r055]

what were you getting done to it this time craig?

[Dave]

There's a thread on exiges.com at the moment that has a few pictures of the plug etc, have a look here.

http://www.exiges.com/ubbthreads/showfl ... o=&fpart=1