Scottish Elises

Do any of you know how much an S1 Exige exhaust will stick out from a standard clam? Its the big ovally rectangle shaped one.

I havent seen an S1 with that exhaust before so if anyone else has how'd it look (but more importantly, sound?)

Wont fit.

My clam has the two holes as above. Its not this one im after, its this one

Will it stick out a mile? The LSS exhaust I think it is.....

Sneaking suspicion Gareth is right. There's more room inside the Exige clam... The standard Exige can absolutely won't fit and I have a sneaking suspicion the Janspeed won't... There is a single oval exit Janspeed available for the S1, however, which the one you're talking about may be.

That rear pipe doesn't look janspeed though, again, don't know them all by sight.

(Lotus Sports zorst is just a badged Janspeed, btw) Be sure and check it fits *inside* the clam before thinking about how far it'll come out.

Do you know what it came off?

here it is

Doesnt say what it is off.

I'm only keen on these ones as I have heard and liked the sound.

All help appreciated!

Cool. didn't know tailpipe length was adjustable... Noted for future ref...

OOOOOOooooh thats sounding good.

I have also found a chap selling an original janspeed exige exhaust with the twin exits. It'll cost me 90notes. Its only been on a car for a few '000 miles, but will the twin pipe one be adjustable?

At 90bucks im thinking, bring it on. Coupled with the 20quid CRP I bought off SELOC, I could be getting lots of nice noise for little $....

Will have a pic by Friday, might just wat until a Janspeed S1 exhaust comes up. dependant on what the one thats on ebay goes for.

Then I have C Service, Road Tax and holiday to pay for this month......