Torque Settings

Cammy · Post by **Cammy** » Fri Jul 14, 2006 3:36 pm

About to remove the cam cover on the 340R to carry out some works. Although I don't think it's critical when re-fitting does anyone know what the fixings should be torqued to

Cheers
Cammy

Rich H · Post by **Rich H** » Fri Jul 14, 2006 5:17 pm

According to the manual start in the centre then proceed clockwise around the head from the centre out wards starting from the 3 o-clock position and torque to 10Nm

Hope this makes sense! Pg 74 in the overhaul manual.

Rich

Cammy · Post by **Cammy** » Fri Jul 14, 2006 5:54 pm

RICHARDHUMBLE wrote:According to the manual start in the centre then proceed clockwise around the head from the centre out wards starting from the 3 o-clock position and torque to 10Nm

Hope this makes sense! Pg 74 in the overhaul manual.

Rich

Thanks Rich. Must get myself a manual.
30 mins to remove, polish & re-fit

Cammy

Rich H · Post by **Rich H** » Fri Jul 14, 2006 5:57 pm

someone who cares for their vehicle so as to ensure its value is retained and they dont drive a shed!

YHPM!