Page 1 of 1
Torque Settings
Posted: Fri Jul 14, 2006 3:36 pm
by Cammy
About to remove the cam cover on the 340R to carry out some works. Although I don't think it's critical when re-fitting does anyone know what the fixings should be torqued to
Cheers
Cammy
Posted: Fri Jul 14, 2006 5:17 pm
by Rich H
According to the manual start in the centre then proceed clockwise around the head from the centre out wards starting from the 3 o-clock position and torque to 10Nm
Hope this makes sense! Pg 74 in the overhaul manual.
Rich
Posted: Fri Jul 14, 2006 5:54 pm
by Cammy
RICHARDHUMBLE wrote:According to the manual start in the centre then proceed clockwise around the head from the centre out wards starting from the 3 o-clock position and torque to 10Nm
Hope this makes sense! Pg 74 in the overhaul manual.
Rich
Thanks Rich. Must get myself a manual.
30 mins to remove, polish & re-fit
Cammy
Posted: Fri Jul 14, 2006 5:57 pm
by Rich H
someone who cares for their vehicle so as to ensure its value is retained and they dont drive a shed!
YHPM!
