Scottish Elises

Hi folks,

Just been helping Alan get his S1 back together and appears he has misplaced the plinths that mount the rear balljoints to the hub. Both rear bottom and top brackets

Has anyone got any of these liying around? Are they the same fron and back? Obviously the top is different but wondered if the bottom was all the same,

C

Are they steel or ali hub carriers Craig makes a difference?

Rear alis have different ball joint carriers top and bottom. Steel has the same upper but does not use a lower.

Front hub carriers are ali. Lower ball joint carrier is the same as the rear, they do not use an upper.

tut

tut wrote:Are they steel or ali hub carriers Craig makes a difference?

Rear alis have different ball joint carriers top and bottom. Steel has the same upper but does not use a lower.

Front hub carriers are ali. Lower ball joint carrier is the same as the rear, they do not use an upper.

tut

??

*all* OEM S1 ball joint carriers are steel.

Front ones are different from rears and are handed (as in Left/Right)

Rears are not handed, same for the rear top plinth carriers.

So he has alloy hubs but as simon says the plinths are steel. He has found one top one but needs two lower and one more top.

Ill message junks and see if he has anything.

C

PS Tut, abbeville.

Junks managed to sort this out