Boot Lid

Titanium S1 111S (gla) · Post by **Titanium S1 111S (gla)** » Thu Mar 29, 2007 12:01 am

Went to open my boot this evening and the opening leaver was jammed solid. No movement at all.

Was late so couldnâ€™t persuade the girlfriend to come out of the warm to lean on the lid but not sure that will help with the leaver being absolutely solid.

Thoughts??

RDH · Post by **RDH** » Thu Mar 29, 2007 12:45 am

A massive spray of WD40 may do the trick

HTH
Rob / no idea how S1 boot lids function faction

Rich H · Post by **Rich H** » Thu Mar 29, 2007 8:18 am

Pull down the wheel arch liner on the RHS rear and fish about for the cable and yank it from there. The handle is the bit that sticks a bit on mine as it's rusty.

when you get the boot open, undo the little cable clamp in the boot and pull out the whole cable from it's inner. I ran a load of WD40 down the cable outer to shift the water then gave the cable a good going over with a cloth & wire brush as required then lubed up the cable with white grease and pushed it back in. Has worked ok for the last 6 months.

Job's a carrot