K and N panel filter

MacK · Post by **MacK** » Tue Apr 10, 2007 11:45 am

Where's the best place to buy a K&N panel filter for a K engined S2?

Checked the K&N website, but they don't list the panel filter just the induction kit.

Rich H · Post by **Rich H** » Tue Apr 10, 2007 1:07 pm

Rover MGF panel?

tuscan_thunder · Post by **tuscan_thunder** » Tue Apr 10, 2007 1:12 pm

Demon Thieves, sorry, Tweeks, list it as a 97 model on so don't think it'll fit but they're looking for £42. They list the MG TF part at £33.89.

The Pipercross panel filter is listed at £34.85 in S1 and S2 form

MacK · Post by **MacK** » Tue Apr 10, 2007 1:19 pm

Is the S1 and S2 panel the same size?

Checked the Demon site, and when going to the check-out bit a security warning comes up and advices against proceeding. Something to do with security ceritificate is for a different address

Phoned them and they are phoneing me back after they check it out.

tuscan_thunder · Post by **tuscan_thunder** » Tue Apr 10, 2007 1:27 pm

pass - dunno!

GregR · Post by **GregR** » Wed Apr 11, 2007 8:25 am

Same size panel, its just the filter box/houseing that's different on S1s and S2s. Go to the Hangar111 site and buy an ITG panel - general consensus on the C*ck was that it was a better panel. I got one there ages ago for circa £35

MacK · Post by **MacK** » Wed Apr 11, 2007 9:06 am

Is it an oiled re-cleanable one like the K&N Greg?

GregR · Post by **GregR** » Wed Apr 11, 2007 10:12 am

Sure is.