Page 1 of 1
K and N panel filter
Posted: Tue Apr 10, 2007 11:45 am
by MacK
Where's the best place to buy a K&N panel filter for a K engined S2?
Checked the K&N website, but they don't list the panel filter just the induction kit.
Posted: Tue Apr 10, 2007 1:07 pm
by Rich H
Rover MGF panel?
Posted: Tue Apr 10, 2007 1:12 pm
by tuscan_thunder
Demon Thieves, sorry, Tweeks, list it as a 97 model on so don't think it'll fit but they're looking for £42. They list the MG TF part at £33.89.
The Pipercross panel filter is listed at £34.85 in S1 and S2 form
Posted: Tue Apr 10, 2007 1:19 pm
by MacK
Is the S1 and S2 panel the same size?
Checked the Demon site, and when going to the check-out bit a security warning comes up and advices against proceeding. Something to do with security ceritificate is for a different address
Phoned them and they are phoneing me back after they check it out.
Posted: Tue Apr 10, 2007 1:27 pm
by tuscan_thunder
pass - dunno!
Posted: Wed Apr 11, 2007 8:25 am
by GregR
Same size panel, its just the filter box/houseing that's different on S1s and S2s. Go to the Hangar111 site and buy an ITG panel - general consensus on the C*ck was that it was a better panel. I got one there ages ago for circa £35
Posted: Wed Apr 11, 2007 9:06 am
by MacK
Is it an oiled re-cleanable one like the K&N Greg?
Posted: Wed Apr 11, 2007 10:12 am
by GregR
Sure is.