Page 1 of 2
RATTLING
Posted: Mon Jul 30, 2007 3:13 pm
by PICKY
Hi all,
I picked up my S2 on Saturday and had a wonderful time, driving back up from Birmingham to Peebles. I have just noticed that there seems to be a rattling noise coming from the rear. Sounds like a loose metal plate or something similar. Does anyone have any ideas what this could be?
My technical knowledge is as good as a baby!
Posted: Mon Jul 30, 2007 3:20 pm
by Rich H
Undertray is probaly loose, go round all the bolts with an 8mm socket and tweak them all tight.
Also empty all the loose change fomr under the seat. You'll find about £20 in pennies...
Posted: Mon Jul 30, 2007 3:22 pm
by ed
Its probably your undertray! IIRC you need a 10 mil spanner/socket to do them up. cheers
Posted: Mon Jul 30, 2007 4:34 pm
by simon
Too slow Ed (and you're wrong)
Posted: Mon Jul 30, 2007 5:12 pm
by ed
Some undertrays have 10mil bolts!
ps i was half right!
Posted: Mon Jul 30, 2007 5:35 pm
by Rich H
Actually out of the 24 bolts 20 are 8mm and 4 are 10mm if memory serves. so you are 83 1/3 % wrong
Bet its the 8mm ones that are loose though....
Posted: Mon Jul 30, 2007 5:36 pm
by Rich H
By the way Ed this is what a spanner looks like:
Posted: Mon Jul 30, 2007 5:47 pm
by robin
On most S2 undertrays the bolts around the rim are M5 with 8mm heads and the four center bolts are M8 with 13mm heads, though some are domed/cap heads instead.
However, on the S2 there is a support plate that lives in the lower rear wheel arches -approximately triangular and more-or-less vertical. That is often loose - you would need to remove the undertray to see it and re-fasten it.
Cheers,
Robin
Posted: Mon Jul 30, 2007 5:55 pm
by Rich H
OK 13mm not 10mm.
You were 100% wrong then Ed...
Posted: Mon Jul 30, 2007 6:09 pm
by Victor Meldrew
So its probly an exhaust heat shield then..
Posted: Mon Jul 30, 2007 8:17 pm
by meatball
Bugger it.......my 111s has started doing the same again!
I blame the author of this post!
Posted: Tue Jul 31, 2007 12:37 am
by ExigeKen
Ali tightenend all mine up tonight and also fitted bolts where some where missing - no more rattles
Posted: Tue Jul 31, 2007 9:57 am
by Rag_It
Yeah Ross, was about to say, get up and see Ali at SLS, you will find a post in here regarding him establishing himself having broken away from Murray's.
Sounds like your car could do with a once over matey, then you can start adding extras...
Will give you a ring tonight and you can tell me all about it!
Dave
Posted: Tue Jul 31, 2007 10:37 pm
by PICKY
thanks a lot guys, I have checked the undertray and there was 2 bolts quite loose. running like a dream again (for now!)
Posted: Tue Jul 31, 2007 10:57 pm
by PICKY
dave
can't seem to find him anywhere?