Scottish Elises

Few pics from Yesterday folks, what a stunning piece of engineering! What a machine out on quiet roads of the borders too!!

Firstly the Engine, By his own admission, Mass knew the Engine bay could be better presented and hoped the new gun I have raved about would do the trick.

Before:-



After:-







I Took a video of the gun in action whilst cleaning the engine so you can see its not just a gimic:-



Then some exterior pictures:-






























The car really has that wet look now, a really deep deep orange colour with the glass like finish.

Ace car, Mass I wish you all the best with your recent purchase.

Thanks again

Ally

Looks fantastic
How dose the gun work?

The old girl scrubs up alright i suppose

Great work Ally, looks fantastic, and congrats again Mass (I'm still 100% tifosi tho )

I love it amazing Mass never gets old looking at this car

I just love seeing a firing order for 12 cylinders.

Great result Ally, beautiful looking car.



tut

ps first pictures I have seen of your house. Definite contender for a mass towers event.

Great work Ali!!!! Car looks AMAZING Mass..

simply stunning

Awesome Mass.

Ally

cant wait to go for a spin in that Mass

Awesome peice of kit

jamie wrote:Looks fantastic
How dose the gun work?

Hi Jamie,

Copied from my initial post on the gun:-



"Hi Jim,

Ok, my best attempt at a description of how it works then!!!

The air pressure from the compressor comes up and through a valve - this can either be set to flow right through to the gun ( Just an air gun effect ) or it opens up the bottle chamber. If this is set, then the air creates a suction, pulling the chemical up through a filter and into the flexi pipe. This pipe rotates within the cone assembly, agitating the chemical at the same time.
The combination of the agitated chemical and the air pressure is what gives the cleaning power.
There is a small hole in the cone ( narrow end ) which creates a form of vacuum, making dirt and debris come back up the cone and held there.
To clean this, all you do is place the open end into a bucket of water and trigger, the closed loop then cleans the cone out and your ready to go again.

As you can imagine, its great for things like air vents, now rather than just dusting them and making them look clean, I can actually force clean them right through by opening the vents and placing a cloth over the mating vent, catching the trapped dirt from the vent chambers.

Ok, that maybe didn't make much sense but I tried!!

Cheers

Ally"


The pressure required to run correctly as Stu pointed out can be an issue so i'm told. At the moment I'm using a 24ltr one but trying to source a 50ltr upright one purely for minimising the space it takes up in the van. By using a imple control valve on the gun you can control the pressure much better, avoiding the problem Stu highlighted.

Ally

I think I just came a little....

looks amazing mass!
i love it!!

Amazing difference seeing the before and after, that gun is quite an impressive peice of kit!

The car looks stunning Mass, cant wait to see it in the flesh!

Thank you for your comments and Ally for the great work. The enguine bay got 10 years younger in a matter of few hours.

that car is incredible.

good work