VVC Short block to std head?

mac · Post by **mac** » Mon Jun 23, 2008 4:16 pm

Does anyone else see the obvious flaw with Steve rebuilding an engine in the kitchen of his flat?

Mac

Rich H · Post by **Rich H** » Mon Jun 23, 2008 4:31 pm

I had a 924 engine dropped off on a pallet on the drive.
That has an Iron block
And it was full of oil
And it had full inlet manifold and iron exhaust on it.
Even in bits I struggled to move it
Its still at the back of the drive under an old water tank...

Yes I can see a slight flaw...

steve_weegie · Post by **steve_weegie** » Mon Jun 23, 2008 4:45 pm

Back bedroom guys, not the kitchen

Even I have standards!!

I got it up ok

What i am worried about is Mr McKeann claiming visiting rights at KH though

Post by **Shug** » Mon Jun 23, 2008 4:46 pm

steve_weegie wrote:
I got it up ok

We want to hear about the engine, not your exploits during the week....

BiggestNizzy · Post by **BiggestNizzy** » Mon Jun 23, 2008 5:09 pm

This sounds kinda cool, ok if I pop over one night to hinder your progress ?

steve_weegie · Post by **steve_weegie** » Mon Jun 23, 2008 5:31 pm

Shug wrote:
steve_weegie wrote:
I got it up ok
We want to hear about the engine, not your exploits during the week....

Even the big blue smiley wouldnt come close to that mate

BiggestNizzy wrote:This sounds kinda cool, ok if I pop over one night to hinder your progress ?

Sure thing. I need to swap blocks across next weekend & buy an engine stand, but you're welcome anytime. Will give you a bell when i'm starting to tear it down

Post by **Shug** » Mon Jun 23, 2008 5:39 pm

steve_weegie wrote:
Shug wrote:
steve_weegie wrote:
I got it up ok
We want to hear about the engine, not your exploits during the week....
Even the big blue smiley wouldnt come close to that mate

Poor bloody lassie - I hope her body could handle the pressure....

steve_weegie wrote:
BiggestNizzy wrote:This sounds kinda cool, ok if I pop over one night to hinder your progress ?
Sure thing. I need to swap blocks across next weekend & buy an engine stand, but you're welcome anytime. Will give you a bell when i'm starting to tear it down

Keep me in the loop too - I'm having ideas about drinking/engine building parties

steve_weegie · Post by **steve_weegie** » Mon Jun 23, 2008 9:39 pm

Shug wrote: Keep me in the loop too - I'm having ideas about drinking/engine building parties

Shug in "get drunk, stip it down and look at the big ends" shocker

Seriously though, I'll get an engine stand and mcKeanns block and sort somthing out shortly

VXJON · Post by **VXJON** » Mon Jun 23, 2008 9:40 pm

BiggestNizzy wrote:This sounds kinda cool, ok if I pop over one night to hinder your progress ?

Scottish Elises

VVC Short block to std head?

Re: VVC Short block to std head?

Re: VVC Short block to std head?

Re: VVC Short block to std head?

Re: VVC Short block to std head?

Re: VVC Short block to std head?

Re: VVC Short block to std head?

Re: VVC Short block to std head?

Re: VVC Short block to std head?

Re: VVC Short block to std head?