gear change problem when hot.

The place to "speak geek"
Post Reply
User avatar
mckeann
Posts: 5370
Joined: Thu Mar 10, 2005 9:20 am
Location: Bo'ness

gear change problem when hot.

Post by mckeann » Wed Jan 21, 2009 6:12 pm

Hi folks

Only just worked this out, as not been doing many long journeys for the past couple of months.

Gearchange is nice and sweet when cold (well, as good as you expect from a K series gearbox :lol: ) but when the car warms up, the self centering dissappears, and it gets quite mushy to move across the gate. Forward/back motion is the same whether hot or cold, and i'm happy with that.


Gearbox oil was replaced last summer, so i doubt its that. Could it just be the linkage needing lubed? or is it possibly a cable?

Its the heat thing that has me stumped, as i'd expect it to free off when warm.


any suggestions??


cheers

neil

User avatar
Shug
Posts: 13835
Joined: Wed Mar 09, 2005 8:28 pm
Location: Deepest, Darkest Ayrshire

Re: gear change problem when hot.

Post by Shug » Wed Jan 21, 2009 6:14 pm

Or the linkage at the box end could tighten as the metal expands with the heat. I'd look at stripping and greasing that all up before moving further...
2010 Honda VFR1200F
1990 Honda VFR400 NC30
2000 Honda VTR1000 SP1
2000 Kawasaki ZX-7R

User avatar
Kayfur
Posts: 500
Joined: Sun Mar 20, 2005 2:46 pm

Re: gear change problem when hot.

Post by Kayfur » Wed Jan 21, 2009 7:13 pm

I had similar symptoms on mine. I fixed by replacing the rear linkage - although I suspect a re-lube would have done just as well. ( I'd already bought the Eliseparts kit )

Kevin.
Exige S
Caterham 7

User avatar
mckeann
Posts: 5370
Joined: Thu Mar 10, 2005 9:20 am
Location: Bo'ness

Re: gear change problem when hot.

Post by mckeann » Wed Jan 21, 2009 10:01 pm

Cheers folks, will lube and/or replace linkage at the rear. It confused me with the heat iddus, as when i have had dodgy gears before, its been at all times.

Thanks.




/ off to phone all to book car in for a service and gear linkage check , lazy faction :oops:

User avatar
meatball
Posts: 5043
Joined: Sun Dec 31, 2006 9:50 pm
Location: LOST!

Re: gear change problem when hot.

Post by meatball » Thu Jan 22, 2009 7:40 pm

My old 111s did that....copper slip the cables and it sorted!

User avatar
TommyK
Posts: 41
Joined: Thu May 22, 2008 9:29 am
Location: Edinburgh/Oxford

Re: gear change problem when hot.

Post by TommyK » Fri Jan 23, 2009 7:31 pm

mckeann wrote:Cheers folks, will lube and/or replace linkage at the rear. It confused me with the heat iddus, as when i have had dodgy gears before, its been at all times.

Thanks.




/ off to phone all to book car in for a service and gear linkage check , lazy faction :oops:
I've got a 135R too and have noticed the same thing. Interested to hear if your strip and lube does the job. :lol:
Performance through tight pants.

User avatar
mwmackenzie
Posts: 4309
Joined: Thu Feb 22, 2007 10:22 pm
Location: Edinburgh

Re: gear change problem when hot.

Post by mwmackenzie » Fri Jan 23, 2009 11:34 pm

Just had mine sorted by Ali, was the bushes on the selector at the gear box £17.50 from Motobuild http://www.moto-build.com
Mark MacKenzie

BMW Z4 3.0si, [R14 MMK] To be Ring ready soon

Fancy Ass Merc thingy S [R4 MMK] 85% MacKenzie'd Family Spec

Post Reply